Technicolor COM2000 Manual do Operador descarregar pdf (Página 45)

identifiers to multiple chassis within a system.

Slot – This field identifies the card’s location within a chassis, numbered 1 through 12. If this

field is grey, the slot number is a link to messages in the CAM Log.

Tuner – There are eight entries per CardIP for this column. This represents the eight tuners

available on each COM46 card.

QAM or IPAddress –If some of the programs are streaming to a QAM6, then “QAM” is

displayed as the column header. If all signals are routed out of the system, then “IPAddress” will

display as the column header instead. If the card is sending video to a QAM6, this field shows

the output QAM channel and QAM sub-channel number. If a card is streaming video to outside

of the chassis, this field will contain the destination IP address. Both unicast and multicast

addresses are supported.

Bitrate or Port – If some of the programs are streaming to a QAM6, then “Bitrate” is displayed

as the column header. If all signals are routed out of the system, then “Port” will display as the

column header instead. If the card is sending video to a QAM6, this field shows the

instantaneous bitrate of the channels being sent out of the QAM6. Otherwise this field contains

the destination port associated with the destination IP address described above. You must have a

unique port number for each individual channel you wish to stream.

Channel – This field shows the Channel Name and the DIRECTV channel number you tune to

on a typical DIRECTV tuner. This field is also a link that permits the user to change channels.

If the smart card has not been authorized or paired then the channel will be highlighted in red.

SNR – This field returns the Signal-to-Noise Ratio associated with the selected tuners. If the

SNR is low, it will be highlighted in yellow and if the SNR is very low, it will be highlighted in

red.

Note: For optimum performance of the COM2000, this value should be 11 or higher.

Strength

– This value provides a value corresponding to the internal Automatic Gain Control

setting in the COM46. If the Strength is low, it will be highlighted in yellow and if the Strength

is very low, it will be highlighted in red.

Note: For optimum performance of the COM2000, this value

should be somewhere between -25 and -55.

This value is nominally the power level at the input of the COM46 card.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 127 128

Sem comentários

Technicolor COM2000 Manual do Operador Página 45