Technicolor COM2000 Manual do Operador descarregar pdf (Página 60)

1 = DHCP_Persistent

In this mode all IP address information Base_IP, Subnet and Gateway are taken from the DHCP

lease that the DHCP server issues to the card and is stored in non-volatile memory.

4 = Fixed

In this mode the user sets the Base_IP, Subnet and Gateway fields. All fields MUST be set. A

Gateway MUST be defined regardless of it being there or not for this mode.

8 = No Change

This setting does not actually represent a separate mode, but rather acts as a way to tell the

COM46 card that you would like it to continue using whatever mode it is currently using. For

example, you could use this selection to tell a card that is already using Fixed mode that you

want it to start using a different IP address by selecting this option and entering a different value

into the “Base_IP” field.

Base_IP – In the Default mode this field will display the IP address of the card. In the

DHCP_Persistent mode this field will display the last address stored in non-volatile memory. In

the Fixed mode this field is where you would enter the IP address you wish to assign to that card.

Subnet – This field allows you to give a subnet mask of your choosing to the COM46 card. This

field is only applied in the Fixed mode.

Gateway – This field allows you to set a default gateway of your choosing for the COM46 card.

This field is only applied in the Fixed mode and must be set when using that mode.

Time-to-Live – Time to Live field in IP protocol header.

Log_IP – This field allows you to direct the COM46 card to send its log files to an external

destination automatically. This is very useful for monitoring the health of the system over an

extended period. After entering the IP address of the destination, the log files will start being

forwarded to this address after a short delay. You may then run a system-logging utility like

Kiwi on the destination computer to capture this information.

Log_Level – This field allows you to define the level of detail that will be captured in the

resulting log files. Due to the complexity of this setting, it is strongly advised that it be left blank

unless someone from support has asked to change the value.

UtilConfig – This field is for development purposes only, and should be left blank unless you

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 127 128

Sem comentários

Technicolor COM2000 Manual do Operador Página 60