Technicolor COM2000 Manual do Operador descarregar pdf (Página 59)

6.2.7 Setting the COM46 User Configuration Options

The information shown in Figure 34 below is one of the subsections available on the Advanced

Edit page.

Figure 34 – “User Config” Interface on Advanced Edit page

This section gives you the ability to customize select features of the COM46 cards to better suit

your application. The cards actually support a few more features than shown here, but the two

most useful features have been made available here. You have the ability to set the IP address

the card uses or to change the mechanism the card uses to obtain IP addresses. You can also

control and configure the sending of log data to a PC or other monitoring mechanism via the

Ethernet.

Following is a brief explanation of each field shown above.

IP_Config – This field allows for one of 3 methods of IP address assignments to be chosen. The

default IP_Config setting is 0.

0 = Default

In this mode the IP address is assigned to the card based on the chassis ID and slot the card is

currently in. The formula for this address is 192.168.3.[1 + (chassis ID X 16) + slot number]

Example: chassis ID = 1 slot = 1 Default IP address = 192.168.3.1 + 16 + 1 = 192.168.3.18

Example: chassis ID = 1 slot = 6 Default IP address = 192.168.3.1 + 16 + 6 = 192.168.3.23

Example: chassis ID = 2 slot = 1 Default IP address = 192.168.3.1 + 32 + 1 = 192.168.3.34

Example: chassis ID = 2 slot = 6 Default IP address = 192.168.3.1 + 32 + 6 = 192.168.3.39

In the Default IP mode the Base_IP and the Gateway fields are ignored. The Subnet field is also

ignored but the Subnet mask is set to 255.255.0.0 and is applied.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 127 128

Sem comentários

Technicolor COM2000 Manual do Operador Página 59